From Wikipedia, the free encyclopedia
Celestial navigation is the use of angular measurements (sights) between celestial bodies and the visible horizon to locate one's position on the globe, on land as well as at sea. At a given time, any celestial body is located directly over one point on the Earth's surface. The latitude and longitude of that point is known as the celestial body’s geographic position (GP), the location of which can be determined from tables in the Nautical or Air Almanac for that year.
The measured angle between the celestial body and the visible horizon is directly related to the distance between the celestial body's GP and the observer's position. After some computations, referred to as "sight reduction," this measurement is used to plot a line of position (LOP) on a navigational chart or plotting work sheet, the observer's position being somewhere on that line. (The LOP is actually a short segment of a very large circle on the earth which surrounds the GP of the observed celestial body. An observer located anywhere on the circumference of this circle on the earth, measuring the angle of the same celestial body above the horizon at that instant of time, would observe that body to be at the same angle above the horizon.) Sights on two celestial bodies give two such lines on the chart, intersecting at the observer's position (actually, the two circles would result in two points of intersection arising from sights on two stars described above, but one can be discarded since it will be far from the estimated position -- see the figure at "example" below). Most navigators will use sights of three to five stars, if they're available, since that will result in only one common intersection and minimize the chance for error. That premise is the basis for the most commonly used method of celestial navigation, and is referred to as the "Altitude-Intercept Method."
There are several other methods of celestial navigation which will also provide position finding using sextant observations, such as the "Noon Sight", and the more archaic Lunar Distance method. Joshua Slocum used the Lunar Distance method during the first ever recorded single-handed circumnavigation of the world. Unlike the Altitude-Intercept Method, the noon sight and lunar distance methods do not require accurate knowledge of time. The altitude-intercept method of celestial navigation requires that the observer know exact Greenwich Mean Time (GMT) at the moment of his observation of the celestial body, to the second -- since every four seconds that the time source (commonly a chronometer or in aircraft, an accurate "hack watch") is in error, the position will be off by approximately one nautical mile.
Contents
Example
In this case the navigator is either located on the Atlantic Ocean, about 350 nautical miles (650 km) west of Madeira, or in South America, about 90 nautical miles (170 km) southwest of AsunciĆ³n, Paraguay. In most cases, determining which of the two intersections is the correct one is obvious to the observer because they are often thousands of miles apart. As it is unlikely that the ship is sailing across South America, the position in the Atlantic is the correct one. Note that the lines of position in the figure are distorted because of the map’s projection; they would be circular if plotted on a globe.
An observer in the Chaco point would see the Moon at the left of the Sun, and an observer in the Madeira point would see the Moon at the right of the Sun, and that whoever measured the two heights was likely to observe also this one bit of information.[citation needed]
Angular measurement
Navigators measure distance on the globe in degrees, arcminutes and arcseconds. A nautical mile is defined as 1852 meters, but is also (not accidentally) one minute of angle along a meridian on the Earth. Sextants can be read accurately to within 0.2 arcminutes. So the observer's position can be determined within (theoretically) 0.2 miles, about 400 yards (370 m). Most ocean navigators, shooting from a moving platform, can achieve a practical accuracy of 1.5 miles (2.8 km), enough to navigate safely when out of sight of land.[citation needed]
Modern practical navigators usually use celestial navigation in combination with satellite navigation to correct a dead reckoning track, that is, a course estimated from a vessel's position, course and speed. Using multiple methods helps the navigator detect errors, and simplifies procedures. When used this way, a navigator will from time to time measure the sun's altitude with a sextant, then compare that with a precalculated altitude based on the exact time and estimated position of the observation. On the chart, one will use the straight edge of a plotter to mark each position line. If the position line shows one to be more than a few miles from the estimated position, one may take more observations to restart the dead-reckoning track.
In the event of equipment or electrical failure, one can get to a port by simply taking sun lines a few times a day and advancing them by dead reckoning to get a crude running fix.
Latitude
Latitude was measured in the past either at noon (the "noon sight") or from Polaris, the north star (assuming it is sufficiently visible above the horizon, which it is not in the Southern Hemisphere). Polaris always stays within 1 degree of the celestial north pole. If a navigator measures the angle to Polaris and finds it to be 10 degrees from the horizon, then he is about 10 degrees north of the equator. Angles are measured from the horizon because locating the point directly overhead, the zenith, is difficult. When haze obscures the horizon, navigators use artificial horizons, which are bubble levels reflected into a sextant.Latitude can also be determined by the direction in which the stars travel over time. If the stars rise out of the east and travel straight up you are at the equator, but if they drift south you are to the north of the equator. The same is true of the day-to-day drift of the stars due to the movement of the Earth in orbit around the Sun; each day a star will drift approximately one degree. In either case if the drift can be measured accurately, simple trigonometry will reveal the latitude.
Longitude
Longitude can be measured in the same way. If one can accurately measure the angle to Polaris, a similar measurement to a star near the eastern or western horizons will provide the longitude. The problem is that the Earth turns 15 degrees per hour, making such measurements dependent on time. A measure a few minutes before or after the same measure the day before creates serious navigation errors. Before good chronometers were available, longitude measurements were based on the transit of the moon, or the positions of the moons of Jupiter. For the most part, these were too difficult to be used by anyone except professional astronomers. The invention of the modern chronometer by John Harrison in 1761 vastly simplified longitudinal calculation.The longitude problem took centuries to solve and was dependent on the construction of a non-pendulum clock (as pendulum clocks cannot function accurately on a tilting ship, or indeed a moving vehicle of any kind). Two useful methods evolved during the 18th century and are still practised today: lunar distance, which does not involve the use of a chronometer, and use of an accurate timepiece or chronometer.
Presently, lay person calculations of longitude can be made by noting the exact local time (leaving out any reference for Daylight Savings Time) when the sun is at its highest point in the sky. The calculation of noon can be made more easily and accurately with a small, exactly vertical rod driven into level ground—take the time reading when the shadow is pointing due north (in the northern hemisphere). Then take your local time reading and subtract it from GMT (Greenwich Mean Time) or the time in east London. For example, a noon reading (1200 hours) near Central Canada or the U.S.A. would occur at approximately 6 pm (1800 hours) in London. The six hour differential is 1/4 of a 24 hour day, or 90 degrees of a 360 degree circle (the Earth). The calculation can also be made by taking the number of hours (use decimals for fractions of an hour) multiplied by 15, the number of degrees in one hour. Either way, you can demonstrate that much of central USA or Canada is at or near 90 degrees West Longitude. Eastern longitudes can be determined by adding the local time to GMT, with similar calculations.
Lunar distance
Main article: Lunar distance
The older method, called "lunar distances", was refined in the
18th century. It is only used today by sextant hobbyists and
historians, but the method is theoretically sound, and can be used when a
timepiece is not available or its accuracy is suspect during a long sea
voyage. The navigator precisely measures the angle between the moon and
the sun, or between the moon and one of several stars near the ecliptic.
The angle naturally will depend on the navigator's position (which he
doesn't know) but he can still hope to correct the angle well enough to
use the tables that give the corresponding angle as viewed from the
center of the earth at a given Greenwich time. The navigator would thumb
through the almanac to find the angle he measured, and thus know the
time at Greenwich. Modern handheld and laptop calculators can perform
the calculation in minutes, allowing the navigator to use other
celestial bodies than the old nine. Knowing Greenwich time, the
navigator can work out his longitude.Use of time
Main article: Marine chronometer Today
The considerably more popular method was (and still is) to use an
accurate timepiece to directly measure the time of a sextant sight. The
need for accurate navigation led to the development of progressively
more accurate chronometers in the 18th century. (See John Harrison) Today, time is measured with a chronometer, a quartz watch, a shortwave radio time signal broadcast from an atomic clock, or the time displayed on a GPS.[citation needed] A quartz wristwatch normally keeps time within a half-second per day.[citation needed]
If it is worn constantly, keeping it near body heat, its rate of drift
can be measured with the radio, and by compensating for this drift, a
navigator can keep time to better than a second per month.[citation needed]
Traditionally, a navigator checked his chronometer from his sextant, at
a geographic marker surveyed by a professional astronomer.[citation needed] This is now a rare skill, and most harbour masters cannot locate their harbour's marker.[citation needed]Traditionally, three chronometers were kept in gimbals in a dry room near the centre of the ship.[citation needed] They were used to set a watch for the actual sight, so that no chronometers were ever exposed to the wind and salt water on deck.[citation needed] Winding and comparing the chronometers was a crucial duty of the navigator.[citation needed] Even today, it is still logged daily in the ship's deck log and reported to the Captain prior to eight bells on the forenoon watch (shipboard noon)[citation needed]. Navigators also set the ship's clocks and calendar.[citation needed]
The celestial line of position concept was discovered in 1837 by Thomas Hubbard Sumner when, after one observation he computed and plotted his longitude at more than one trial latitude in his vicinity – and noticed that the positions lay along a line. Using this method with two bodies, navigators were finally able to cross two position lines and obtain their position – in effect determining both latitude and longitude. Later in the 19th century came the development of the modern (Marcq St. Hilaire) intercept method; with this method the body height and azimuth are calculated for a convenient trial position, and compared with the observed height. The difference in arcminutes is the nautical mile "intercept" distance that the position line needs to be shifted toward or away from the direction of the body's subpoint. (The intercept method uses the concept illustrated in the example in the “How it works” section above.) Two other methods of reducing sights are the longitude by chronometer and the ex-meridian method.
While celestial navigation is becoming increasingly redundant with the advent of inexpensive and highly accurate satellite navigation receivers (GPS), it was used extensively in aviation until the 1960s, and marine navigation until quite recently. But since a prudent mariner never relies on any sole means of fixing his position, many national maritime authorities still require deck officers to show knowledge of celestial navigation in examinations, primarily as a back-up for electronic navigation. One of the most common current usages of celestial navigation aboard large merchant vessels is for compass calibration and error checking at sea when no terrestrial references are available.
The U.S. Air Force and U.S. Navy continued instructing military aviators on its use until 1997, because:
- it can be used independently of ground aids
- has global coverage
- cannot be jammed (although it can be obscured by clouds)
- does not give off any signals that could be detected by an enemy [1]
Likewise, celestial navigation was used in commercial aviation up until the early part of the jet age; it was only phased out in the 1960s with the advent of inertial navigation and doppler navigation systems, and today's satellite based systems which can locate the aircraft's position accurate to a 3-meter sphere with several updates per second.
Celestial navigation continues to be taught to cadets during their training in the Merchant Navy and remains as a requirement for their certificate of competency.
A variation on terrestrial celestial navigation was used to help orient the Apollo spacecraft en route to and from the Moon. To this day, space missions, such as the Mars Exploration Rover use star trackers to determine the attitude of the spacecraft.
As early as the mid-1960s, advanced electronic and computer systems had evolved enabling navigators to obtain automated celestial sight fixes. These systems were used aboard both ships as well as US Air Force aircraft, and were highly accurate, able to lock onto up to 11 stars (even in daytime) and resolve the craft's position to less than 300 feet (91 m). The SR-71 high-speed reconnaissance aircraft was one example of an aircraft that used automated celestial navigation. These rare systems were expensive, however, and the few that remain in use today are regarded as backups to more reliable satellite positioning systems.
Celestial navigation continues to be used by private yachtsmen, and particularly by long-distance cruising yachts around the world. For small cruising boat crews, celestial navigation is generally considered an essential skill when venturing beyond visual range of land. Although GPS (Global Positioning System) technology is reliable, offshore yachtsmen use celestial navigation as either a primary navigational tool or as a backup.
Intercontinental ballistic missiles use celestial navigation to check and correct their course (initially set using internal gyroscopes) while outside the Earth's atmosphere. The immunity to jamming signals is the main driver behind this apparently archaic technique.
Celestial navigation trainers combine a simple flight simulator with a planetarium in order to train aircraft crews in celestial navigation.
An early example is the Link Celestial Navigation Trainer, used in the Second World War.[4][5] Housed in a 45 feet (14 m) high building, it featured a cockpit which accommodated a whole bomber crew (pilot, navigator and bombardier). The cockpit offered a full array of instruments which the pilot used to fly the simulated aeroplane. Fixed to a dome above the cockpit was an arrangement of lights, some collimated, simulating constellations from which the navigator determined the plane's position. The dome's movement simulated the changing positions of the stars with the passage of time and the movement of the plane around the earth. The navigator also received simulated radio signals from various positions on the ground.
Below the cockpit moved "terrain plates" – large, movable aerial photographs of the land below, which gave the crew the impression of flight and enabled the bomber to practise lining up bombing targets.
A team of operators sat at a control booth on the ground below the machine, from which they could simulate weather conditions such as wind or cloud. This team also tracked the aeroplane's position by moving a "crab" (a marker) on a paper map.
The Link Celestial Navigation Trainer was developed in response to a request made by the Royal Air Force (RAF) in 1939. The RAF ordered 60 of these machines, and the first one was built in 1941. The RAF used only a few of these, leasing the rest back to the U.S., where eventually hundreds were in use.
See also
External links
- Celestial Navigation Net
- Table of the 57 navigational stars with apparent magnitudes and celestial coordinates
- John Harrison and the Longitude problem at the National Maritime Museum, Greenwich, England
- Calculating Lunar Distances
- Navigational Algorithms
- Backbearing.com Almanac, Sight Reduction Tables and more.
- Navigation Spreadsheets Free Excel spreadsheets including almanac data, sight reduction calculations, and much more.
No comments:
Post a Comment